Instruction Manual

（3）Warning display

z If an error occurs during the operation, the centrifuge will brake to stop automatically, and display the

error code on the time/display area. The error code can be checked in the table 10-1, and corrective

actions can be applied accordingly.

8.1.4 End the operation

（1）The centrifuge will brake when it reaches the set time or

button is pressed.

z When the rotor stops rotating, the centrifuge will start beeping to alert the operation has finished.

（2）Open the door

z The door can be released automatically when the operation has stopped.

z With the door closed, you are able to press the

button to open it.

z After ending the operation, the program will store the setting parameters of this operation, and will

recall these parameters when restarting the program.

（3）Open the door and take out the rotor and samples.

8.2 RCF operation

（1） Turn on the power switch

（2） Set a RCF (Relative Centrifugal Force) value

CAUTION

z Do not exceed the allowable maximum RCF value of the rotor and adapters.

z Press the select button and choose speed unit ×g, the speed symbol will flash into RCF value

input status.

z If no button is pressed after the speed value has flashed after 5 seconds, the input mode will be shut

down.

z Rotate program button to input a RCF value, RCF increment is10×g.

（3）Set operating conditions

The other operation, please refer to the section 8.1.