User Manual

Hybex® Microarray Incubation System — USER MANUAL
Version 1.1E, August 2012 6 [phone], [e-mail]
III. USING YOUR HYBEX® MICROARRAY INCUBATION SYSTEM
A. Components, Controls and Accessories
Note: A heat block, waterbath insert or microarray chambers are required for operation.
For a list of available accessories, see section VII. Ordering Information.
Name Function
Power Switch Turns on main power to unit
Temperature Controller Used to set and observe block temperature
Heated Lid Heats the sealed air around the block
Temperature Probe Senses the temperature of the block
Digital Thermometer Jack For calibrating system temperature
2x Microarray Incubation Chamber For array hybridization
Heat Block*(0.2, 0.6, 1.5 ml tubes or microplate) Heats tubes or plates without cap condensation
Waterbath Insert* For heating buffers or water
Digital Thermometer* For calibrating system temperature
*Optional accessories
Temperature Controller
Power Switch
O
F
F
O
N
W
A
T
L
O
W
S
D
3
1
Temperature Probe
Heated Lid
C
F
J
E
N
C
O
M
A
X
M
I
N
R
E
S
E
T
7
0
0
1
H
Microarray Incubation Chamber
Cat. #1057-38-0 (Kit)
Heat Block
0.2 ml: Cat. #1057-31-0
0.6 ml: Cat. #1057-33-0
1.5 ml: Cat. #1057-34-0
Waterbath Insert
Cat. #1057-35-0
Digital Thermometer
Cat. #1051-52-0
Digital
Thermometer
Jack
Power Cord
Receptacle
BACK OF UNIT
Heated Lid
Power Switch
Temperature
Probe
Temperature Controller
Heat Block for
Flat Bottom Microplate
Cat. #1057-39-0