Operating instructions

ASSEMBLY
SCIFIT • Scientific Solutions for Fitness • SCIFIT • Scientific Solutions for Fitness • SCIFIT
5
Assemble Monocoque Frame to Base Frame
With the aid of a second person, align bottom mounting
threaded nutserts of Monocoque Frame with the Base
Frame mounting holes.
To aid in maintaining alignment,
(A) insert a long needle
point center punch through the access hole, mounting hole
of base frame and threaded nut-sert. From the front side
of monocoque frame (B) push up on frame until nut-serts
are aligned with mounting holes. (C) In the forward most
access hole, insert 5/16-18 x 3/4” bolt, 5/16” flat split-lock
washer and 5/16” flat washer, and thread into nut-sert.
Do not tighten bolt. (D) Repeat process for the center
hole. (E) Pull center punch out and install bolt and wash-
ers. Start Opposite Side - Push in slightly on monocoque
frame untils holes are lined up. (F) Start the first bolt and
washers, Do not tighten bolt. Repeat process for the two
remaining holes. Tighten all bolts to 40 ft/lbs (5.53 kg/m).
2
3
1
Assembly
For equipment that is shipped overseas, some assembly is
required. Follow the steps below for assembly.
(E)
(A)
(C)
(B)
(D)
(F)
Required Tools:
Long Needle Point Center Punch
5/16” Allen Drive Socket
1/4” Allen Drive Socket
Required Parts:
Item Qty. Description Part #
1 4 5/16-18 x 3/4” 3112SCH
Socket Cap Head Screw
2 4 5/16 Flat Split Lock Washer 31WS
3 4 5/16 Flat Washer 31W
Assemble Swivel Seat to Seatpost
(A) Adjust yellow swivel lever to the down position.
(B) Lower seat assembly onto seatpost until seat is
fully seated. Raise the swivel lever and rotate seat until
seat locks into position. (C) Tighten seat mounting
collar bolt with a 1/4” allen drive socket, do not over
tighten.
Yellow Swivel
Lever
(A) Push Down
to Mount Seat
(C) Tighten
Collar Bolt
(B) Lower Seat
onto Post