Operating instructions

ASSEMBLY
SCIFIT • Scientific Solutions for Fitness • SCIFIT • Scientific Solutions for Fitness • SCIFIT
7
Left Hand
Crank Handle
Right Hand
Crank Handle
Assemble Hand Crank Handles to Hubs
Identify Left and Right Hand Crank Handles
(A) Insert parallel rods through bearing holes of hub.
(B) Pull yellow crank arm locking pin out and push
rods through until end of rod protrudes from farside.
Release pin and move arm until it locks into position.
(C) To prevent unwanted dropping of crank arm when
adjusting crank arm positions, install a 1/4-20 x 1/2”
socket button head screw and 1/4” washer into the
end of each rod.
1/4-20 x 1/2”
SBH Screw
1/4”
Washer
Left Hand Crank
Handle Shown
(A)
(B)
(C)
Wheelchair Platform
For equipment that is shipped assembled, the
wheelchair platforms need to be installed.
With the aid of an assistant, carefully raise the base
up, and lower the work console down until the console
is resting on the floor. To prevent damage to the case,
place a pad, piece of carpet or cardboard between the
case and floor.
(A) With a 1/2” socket, loosen the four
top bolts that secure the Stainless Steel Adjustment
Track to base frame, just enough to slide the platform
under the lockwasher. NOTE: Do Not remove or
loosen bolts more than necessary. (B) Engage
slots of wheelchair platform over the four bolts,
between the lockwasher and square tube. With the
flat horizontal surface of the wheelchair platform flush
against base frame square tube, (C) tighten the four
bolts. Repeat process for the opposite side.
Protective Pad
(A) Loosen
Four (4) Bolts
(B) Slide Slots
Under Washers
(C) Tighten Bolts