Operating instructions

ASSEMBLY
SCIFIT • Scientific Solutions for Fitness • SCIFIT • Scientific Solutions for Fitness • SCIFIT
5
Required Tools:
1/2” Socket with Ratchet
Long Needle Point Center Punch
5/16” Allen Drive Socket
1/4” Allen Drive Socket
Mount Wheelchair Platforms to Base Frame
Locate two Wheelchair Platforms (A2502) and with the aid
of an assistant, stand Base Frame on its non wheeled end.
(A) With a 1/2” socket, loosen the four middle bolts that
secure the Stainless Steel Adjustment Track to base frame,
just enough to slide the platform under the lockwasher.
NOTE: Do Not remove or loosen bolts more than
necessary. (B) Engage slots of wheelchair platform over
the four bolts, between the lockwasher and square tube.
With the flat horizontal surface of the wheelchair platform
flush against base frame square tube, (C) tighten the four
bolts. Repeat process for the opposite side.
Required Parts:
Item Qty. Description Part #
1 2 PRO Wheelchair Platform A2502
2 4 5/16-18 x 3/4” 3112SCH
Socket Cap Head Bolt
3 4 5/16 Flat Split Lock Washer 31WS
4 4 5/16 Flat Washer 31W
Assembly
Some equipment shipped overseas assembly is required.
Follow the steps below for assembly.
Monocoque Frame is top heavy. Two people are
required to position frame in place. Failure to support
frame properly may result in injury to yourself and/or
others.
CAUTION
Assemble Monocoque Frame to Base Frame
With the aid of a second person, align bottom mounting
threaded nutserts of Monocoque Frame with the Base
Frame mounting holes.
To aid in maintaining alignment
, (A) insert a long needle
point center punch through the access hole, mounting hole
of base frame and threaded nut-sert. From the opposite
side of center punch, (B) push up on monocoque frame
until nut-serts are aligned with mounting holes. (C) Insert
5/16-18 x 3/4” bolts, 5/16” flat split-lock washers and 5/16”
flat washers, through access holes and thread screws into
nut-serts. Do not tighten bolts. (D) Return to center
punch side and thread the forward screw and washers. (E)
Pull center punch out and install the final bolt and washers.
Tighten all bolts to 40 ft/lbs (5.53 kg/m).
(A)
(B)
(C)
(D)
(E)
3
4
2
1
(A) Loosen
Four (4) Bolts
(B) Slide Slots
Under Washers
(C) Tighten Bolts