Install guide

61
• The cable from the power switch or filter (if equipped) has two (2) wires
on the newer treadmill while the older treadmills have three (3) wires.
The blue wire connects to BC4 Common, the brown wire to BC5 A/C
IN, and the green wire (on the older treadmills only) to BC9 FRAME.
• The cable from the lower PCB to the fuse block also differs. Newer
treadmills have a gray-jacketed cable with a large white, Molex header.
This plugs into the lower PCB at JP9. The older treadmills have one
(1) brown and two (2) blue wires from the terminal block to the lower
PCB. The brown wire connects to BC3 COM, the top blue wire to BC2
UP, and the bottom blue wire to BC1 DOWN.
• The elevation potentiometer cable plugs into JP1.
• The 8-pin Telco cable plugs into P2, while the 6-pin Telco plugs into P1
(label not visible).
• The speed sensor cable plugs into JP2.
• The red lead from the drive motor plugs into BC6 A1+, while the black
lead plugs into BC7 A2.
9. Double-check all connections.
10. Restore power to the treadmill.
11. Recalibrate speed following the instruction in Club Mode depending on
your software version. See Club Mode (Pages 27-32).