Install guide

58
7. Remove upper PCB.
8. Using a 1/16” Allen wrench, remove the two (2), 4-40 X ½” screws holding
the magnetic switch (P1522) in place.
9. Pull magnetic bracket (P1609) loose and reinsert on the new membrane.
10. Place the magnetic switch flat side down and start the two (2), 4-40 X ½”
screws through the slots in the switch.
11. Slide switch completely to the right and tighten screws.
12. Replace upper PCB and install the eight (8) Philips screws.
13. Reconnect the ribbon cables.
14. Rest bottom of membrane on the cutout in the upper console. Tilt the top
of the membrane back toward you. This will create enough room for you
to access the wires and the back of the upper PCB.
15. Reconnect wires to the upper PCB.
• The wireless heart rate cable comes out of the left side of the console.
This component has a gray cable with the 3-pin Molex header and
connects to the horizontally mounted, 3-pin connector on the left,
backside of the upper PCB.
• If your treadmill is equipped with contact heart rate, a black cable with
a 3-pin Molex header will be coming from the left side of the console.
This plugs into the vertically mounted, 3-pin header just below the
wireless heart rate header.
• Plug the 6-pin and 8-pin, gray Telco cables into the black headers on
the bottom, center part of the upper PCB.
• If your unit is equipped with Cardio Key, there will be a gray cable with
a 4-pin Molex header coming through the right side of the console.
This plugs into the vertically mounted header on the right, backside of
the upper PCB.
• Broadcast Vision is another optional feature of the treadmill. If your
unit is set up for this option, there is a black, 8-pin Telco cable coming
into the console housing. Its location depends on where the user
decided to mount the keypad. This plugs into the black header that
sits by itself on the right, backside of the upper PCB.
16. While making sure not to pinch any wires, lay the display down into the
console housing.
17. Insert the four (4) display screws through the console back plate and into
the standoffs.
18. Snug these screws until secure. Do not heavily torque.