Install guide
46
8. Remove the rear feet. Using a 9/16” wrench, hold the head of the bolt that
runs through the center of the foot spacer (A1249) and into the foot pad
(P1250). Rotate the foot pad until it unthreads completely from the bolt.
Repeat this procedure for the other foot removal.
9. Using a ½” wrench and socket, remove the bolts that hold the end cap
brackets to the welded tabs of the rear cross member.
10. Pull end caps out of the extrusions.
11. Remove both rear roller tension bolts and the tension brackets (P1439).
12. Slide the running belt to one side or the other.
13. Pull the rear roller (A1245) out of the treadmill.
14. Install the two (2) 1” rubber caps (P1487) from old roller onto new roller.
15. With the running belt slid over, install the new rear roller into the
extrusions, making sure the threads for the tension bolts can be seen.
16. Position each tension bracket over the lips of the extrusion from which
they were removed. With a mallet, tap the bracket onto lips of the
extrusion. Do the same to both sides.
17. Insert the rear roller tension bolt through each bracket and into the rear
roller. Once the threads catch, turn each bolt approximately 3-4 turns.
18. Push each end cap bracket back into the appropriate extrusion.
19. Line up the holes in the end cap bracket with the holes in the extrusions
and welded tabs of the rear cross member.
20. Insert the bolts for the foot pads and spacers on each side. This bolt will
run from inside the extrusion on down through hole.
21. Slide spacer onto each bolt followed by the flat washer and foot pad.
Place 9/16” wrench onto bolt head and turn foot pad clockwise until tight.
22. Insert each of the bolts that run up through the welded tabs and the end
cap brackets. Put a 5/16”-18 nylock nut on each bolt and tighten down.
23. Install front roller by laying it inside the running belt at a 90º angle. Once
the pulley of the front roller clears the deck, slide the drive belt over it.
Proceed to rotate roller until it gets to its normal mounting position. Place
the front roller spacer between front roller and the extrusion. Install and
tighten the 3/8” bolt.