Install guide

29
7. Calibrate Elevation
If you have calibrated the speed, you will need to reenter the Club Setting Mode
again. Press SELECT until “CALE” is shown in the top display. This setting
calibrates the elevation of the treadmill. Press the ELEVATION UP and
ELEVATION DOWN switches simultaneously for three (3) seconds to enter the
elevation calibration subprogram. “ECAL” will be shown in the top display.
Press START.
The top display will show the high grade selected the Factory Settings Mode,
which is “25.0”. The speed display will show “UP2”. The elevation display
shows position in the 256-bit scale used by the software as indicated by the
elevation potentiometer (it should be more than 225 when the treadmill is
completely elevated). The treadmill will elevate to the high limit switch. The top
display will then change to “0.0” which is the low grade set in the Factory Settings
Mode. The speed display will show “dn4”. The elevation display should be less
than 30 when the treadmill is completely lowered. The treadmill will descend to
the lower limit switch. The software will automatically create a scale based on
the difference in resistance of the potentiometer from the upper to the lower limit
switches.
When the elevation calibration is complete, the top display will show “ECAL” and
the speed display will show the lower grade limit and the elevation display will
show the upper grade limit (both in terms of the scale value). Press START and
the system will reboot, load data and resume normal operation.
H. Club Mode (Version 10.1-10.5 Software)
The Club Mode enables club owners and managers to customize certain features
of the DC1000 treadmill. Press the ELEVATION UP and ELEVATION DOWN
arrows simultaneously for three (3) seconds to enter this mode. (Press the keys
until “UnIt” is shown in the top display)
1. Unit of Measure
This setting determines whether English or metric units of measure will be
displayed. The top display will show “UnIt”. The speed display will show “brl” or
Sl”. “brl” represents British or English units (miles) and “S1” represents metric
units (kilometers). Select the unit of measure by using the SPEED UP, SPEED
DOWN, ELEVATION UP, or ELEVATION DOWN keys. After selecting the
desired unit of measure, press the SELECT key to advance to the next setting.
2. Duration.
This setting allows the owner/manager to select the maximum workout time,
which will be available to the user. The speed display will show “dUr”. The