User Manual
Table Of Contents
- Unpacking and Setup:
- Good Measurement Practices:
- Front Panel Controls:
- Balance Functions and Features:
- Autocalibration – To Calibrate the balance to an
- Autocalibration – To Calibrate the Balance to a M
- Autocalibration – To Calibrate the Balance and it
- RS-232 Command for CAL 1 Using the Internal Weight:
- (CAL 2) Linearity:
- (PCS) Front Panel Parts Counting:
- (HI-OK-LO) Checkweighing / Process Control Limits:
- (%) Percent Weighing:
- () Live Animal Weighing / Severe Environment Weighing:
- Floating Tare™ \(dual range models only\):
- Capacity Tracker:
- Selectable Filters, Stability Indicator, and Send-When-Stable:
- Density Determination:
- Below Balance Weighing:
- Specific Gravity Determination:
- Security Bracket:
- Options:
- RS-232 Interface:
- Troubleshooting Guide:
- Environmental Requirements:
- CE Mark:
- Specifications for SM Semi Micro Balances:
- Specifications for SA Analytical Balances:
- Specifications for SP Precision Balances:
- Specifications for SL Laboratory Balances:
- Specifications for SG General Balances and SE Gem Balances:
- Limited Warranty:
- Extended Warranty:
- Returned Goods Procedure:
- Disposal of Electrical and Electronic Equipment:
- Quick Setup Guide:
Quick Setup Guide:
Adjust the FRONT FEET to level the balance by centering the
LEVEL INDICATOR.
5 CONNECT BALANCE
TO ELECTRICAL OUTLET
3 LEVEL BALANCE
4 UNLOCK CLAMPING SCREW
1. Remove the paper tag.
2. Turn the knob, in the direction shown until finger tight.
See page 4 of the manual.
2 PLACE IN PROPER
ENVIRONMENT
1 UNPACK BALANCE
turns but stays
but does not rotate.
The shaft moves in and out
against bottom of case.
in the same position
Thumbwheel
Calibration instructions in manual.
7 WARM UP 1 HR, THEN
CALIBRATE
Press the ON/OFF switch and make sure the balance
goes through the following sequence.
6 TURN ON BALANCE
Rotating thumbwheel('s) as
RAISES front of balance.
extend out of case and
shown causes Shaft to
28