User's Manual

BASE UNIT
Front Panel Side Panel
Rear Panel
1. ALARM OUT SELECTOR: Set the Alarm Relay Output terminals as DC output or dry contacts when the
relay activates.
2. Terminal Board (Refer to the APPENDIX A-5): One pair of Alarm Relay output, +12VDC (12~15V
/300mA max.) output and ground terminal, three wire sensor inputs, two Aux. outputs.
3. COM1 (Refer to the APPENDIX A-2, A-3): Communication port for USB/RS-232 Adaptor, Ethernet
Adaptor and Data Communication Module.
4. COM2 (Refer to the APPENDIX A-4, A-6): Communication port for Relay Module (XRM-01)/X-10
Power Line Interface Controller.
Key Board & Status Display
Emergency Buttons
Speaker
LCD Display
Key Board
LED status
Microphone
To trigger the Emergency help
,
press both buttons simultaneously.
Speaker Volume Control
Power adaptor I/P
2. Terminal Board
Telephone Line I/P
Phone Set Connector
Wire Duct
1.ALARM OUT SELECTOR
3.COM1
4.COM2
5.AUX. Audio
3
Key A & AWAY ARM
Key B & HOME ARM
Key C, STATUS CLEAR & PAUSE
Key D, DISARM & ENTER
Key 1 & Hands-free Telephone
Key 2 & Switch Control
Key 3 & Alarm Relay Control
Key 4 & Door Open (Reserved)
YES
NO
FUNC / ESC
Key 5 & message in reading (Refer to A-1)