User's Manual

(4-4) Set Device Enroll Device Controller Enroll
Burglar Sensor Enroll
Fire Sensor Enroll Zone Number
Medical Button Enroll
Special Sensor Enroll
Change Device Setting (4-4-1)
Delete Device Controller Delete
Burglar Sensor Delete
Fire Sensor Delete Zone Number
Medical Button Delete
Special Sensor Delete
Special Sensor Limit Set Enter Zone Number High/Low Limit
Wire Sensor Assignment Select Input Select Type (4-4-1) Enable State
Enroll Device: The LS-30 uses smart code technology. The Base Unit identifies its sensors by their unique
IDs, so the Base Unit has to learn all the sensors’ ID code in the initial system setup. (Each sensor has
a unique ID that is preset at the factory.)
60 seconds for Device Enroll
After initiating the Enroll Device procedure, there is a 60-second time window for the
device to transmit a RF signal to complete the code learning.
Delete Device: Remove the device from the system.
Special Sensor Limit Set: Set High/Low trigger limits for Special sensors like temperature sensor and
humidity sensor. Please refer to the special sensor’s user guide.
Wire Sensor Assignment: Set the parameters for the wire sensor inputs from the rear panel.
Up to three wire sensors can be assigned.
(The wire sensor input can be selected as a close or open trigger.
The Zone numbers of the wire sensors are fixed to “00-01=Aux1”, “00-02=Aux2”,
“00-03=Sensor In”.)
28