User's Manual

Telephone Line Cut Detection: Permanent OFF /Away Mode ON /Permanent ON

(default, Permanent OFF)

The LS-30 checks the telephone line voltage and if the line voltage is abnormal, the siren will go off

(the Inner Siren should be switched on) to alert the user. (refer to (4-5) Set Siren - Inner Siren.)

Permanent OFF: Never check the telephone line state.

Away Mode ON: Check the telephone line state only in AWAY mode.

Permanent ON: Always check the telephone line state.

Note: To implement this function the telephone line must not connect any auto answering devices

like FAX machine or TAM (Telephone Answer Machine).

Cease Dialing Mode: 30 Minutes /CMS Report OK (default, 30 Minutes)

30 Minutes: The auto-dialer stops dialing after 30 minutes or after all the telephone numbers

have been dialed 5 times without a successful connection.

CMS Report OK: The auto-dialer stops dialing after the report to CMS is successful.

The Latchkey number still will be dialed when the Latchkey Controller Arms/Disarms the system

or the detection of Power Loss/Restore event, even this status is set as “CMS Report OK”.

Tel. Ring: ON/OFF (default, OFF)

Tel. Ring ON: Sound the ringer for incoming calls.

Tel. Ring OFF: Ringer deactivated for incoming calls.

Dial Tone Check: Enable/Disable (default, Enable)

Dial Tone Check Enable: The auto-dialer checks for a dial tone before dialing.

Dial Tone Check Disable: The auto-dialer will not check for a dial tone and dials immediately.