User's Manual

DIAL-IN CONTROL
User can control and check with your LS-30 from a phone anywhere in the world by enabling the
auto-answer function (refer to (4-2) Set Telephone – Set Auto Answer) and set the ring count number.
Notes: 1. If you connect a fax machine or auto-answering machine on the same telephone line, you might
need to refer to their manuals and Appendix A-7 to avoid any disoperation.
2. The ring count number is only effective for the dial-in from PSTN (land line) and it should be
over three rings; otherwise, the noise on the phone line may trigger the dial-in control process.
3. The pulse-dialing phone set can’t dial in to control the system.
The operation of dial-in control is as follows:
1. Dial the telephone number to which LS-30 is connected.
2. After the preset ring count number (for land line), you will hear beeps.
3. Key in the user password (preceded by * and followed by # ) from the telephone keypad within 30
seconds. If the system recognizes the password you will hear beeps, otherwise you should enter again.
4. After the password has been recognized, the LS-30 will enter into monitoring mode for 30 seconds and
then -after two beeps- the system will enter into 2-way hands-free speaker phone automatically. Ten (10)
seconds before the termination of the telephone connection, one beep will be delivered to remind the user.
5. During the 60 seconds, you can also enter commands from the telephone keypad to control the LS-30.
* 0 : Disarm the LS-30 after you exit Dial-in Control (echoed by voice).
* 1 : Arm the LS-30 in Home Mode after you exit Dial-in Control (echoed by voice).
* 2 : Arm the LS-30 in Away Mode after you exit Dial-in Control (echoed by voice).
* 3 : Enter into speak-only mode (echoed by “OK”).
* 4 : Check alarm event and operation mode (echoed by voice).
* 5 : Enter 2-way hands-free speaker phone (echoed by “OK”).
* 6 x x 1 : Turn on the switch number x x (xx = 01-15) (echoed by “OK”).
* 6 x x 0 : Turn off the switch number x x (xx = 01-15) (echoed by “OK”).
* 7 1 : Turn on the Relay (echoed by “OK”).
* 7 0 : Turn off the Relay (echoed by “OK”).
* 8 : Enter into listen-only monitoring (echoed by “OK”).
* 9 : Disconnect the line immediately.
Any other keys will extend the monitoring period for another 60 seconds (echoed by beeps).
The Process of Dial-in Control
Dial Phone Number Enter Password 60 sec. Monitoring &
Ring count as preset within 30 seconds 2-way Communication
----------- *xx--xx# Ready for key tone command
18
Ring Ring