User's Manual

OPERATION MODES OF LS-30
The LS-30 can be set into three operation modes to fulfill your requirements in different times and
situations.
AWAY Mode: When you leave your home or business, set the system into Away Mode.
(Hot Key) Enter into AWAY Mode
Away Mode Arming Sequence
Disarm Exit Delay AWAY mode active →
System status:
↑ (0-255 seconds)
Set AWAY mode
Note: When you place the LS-30 in AWAY Mode, the Base Unit will clear any previous alarm and
warning status on the LCD & LED and check the state of the Door Magnet sensors. If any of
the sensors is still open (for example, you forgot to close the back door before you leave), the
Base Unit will issue a warning message (insert 20 seconds Exit Delay automatically if no Exit
Delay has been set) and show the zone number of the sensor on the LCD display for you to
check.
HOME Mode: In this operation mode, those burglar sensors with their Enable State - Home Mode =
Active will still be on alert and offer the protection you need while at home. (Refer to (4 4-1)
Installer Mode - Set Device - Change Device Setting - Burglar Sensor - Enable State - Home
Mode = Active.)
(Hot Key) Enter HOME Mode
Note: When you place the LS-30 in Home Mode, the Base Unit will check the status of the Door
Magnet sensors. If any of the sensors is still open (for example, you forgot to close the back
door), the Base Unit will issue a warning message and show the zone number of the sensor on
the LCD display for you to check.
The Base Unit will clear any previous alarm and warning status on the LCD &LED when the
Home Mode is entered from the Disarm Mode.
DISARM/ MONITOR Mode: The LS-30 will not issue any alarm for Burglar sensors, but 24-Hour
Zone sensors (refer to (4-4-1) Change Device Setting - Burglar Sensor - 24-Hour Zone),
Fire sensors, Panic, Medical Buttons and Special sensors still work all the time.
(Hot Key) Enter DISARM MODE
Note: About Monitor Mode Please refer to (3) Master Mode- Monitor Mode.
15