User's Manual

Monitor Mode: In this mode all the trigger signals from the Burglar Sensors (not including the sensors
assigned in Group number 91-99 Partial Arm Zones) will be recorded in the Event Log as trigger
signals only; no alarm will be issued. The purpose of this mode is for the recording of all activities in
the protected area while in Disarm Mode. The system will return to Disarm Mode only by changing
state in this setting or from COM1 port command.
Set Partial ARM:
Groups 91 to 99 are nine independent protected zones and these zones can be Armed /Disarmed
individually. (Please refer to APPENDIX A-8)
Set COM1 Control: (default Enable, No Need Password)
Control Enable: The COM1 interface is open for the user to access the system.
Need Password: Password (Only Master and CMS passwords can access the LS-30.) must be
attached to the control commands from the COM1 port.
(If “Need Password” is set on the Base Unit then the password must be set when
running the HyperSecureLink software also. Refer to “HyperSecureLink” User
Guide.)
No Need Password: No password needed for the control commands from the COM1 port.
Control Disable: The COM1 port interface is closed.
Note: If this setting is disabled. The Base Unit can’t communicate with the RS-232/USB
Adaptor, Data Communication Module and Ethernet Adaptor.
Set Switch (Default X-10 type):
X-10 Type: House Code <A-P>: (default <A>)
This code should be the same as the House Code set on the X-10 switches, user can select from
A to P.
Set Switch Auto Control: Set the switch working schedule for automation control applications.
(please refer to the X-10 device operation instruction.)
Entry Delay: Refer to Installer Mode (4-1) Entry Delay.
Exit Delay: Refer to Installer Mode (4-1) Exit Delay.
* Deny Arm if not Ready (Default =No):
System will not enter into “Away” or “Home” mode if not all the door or window magnets are closed.
(This function only valid for the control command from Remote Controller, Keypad, Key board on
the panel and rear panel control input. Arming control from COM1 command, phone dial-in and
scheduled Auto Operation will not affected by this setting.)
Set Password:
Latchkey User: User 9 and User 10 are also called Latchkey Users. The LS-30 will dial the Latchkey
Number (Refer to (4-2-1) Set Telephone Number- Latchkey Number) when these users
arm or disarm the system.
*Duress Code (Default 8862): This code is used to notify the CMS (Central Monitoring Station) that
an emergency event has occurred that requires immediate assistance. When using this code to
set the operation mode, the system will send a duress event to the CMS immediately.
14