User's Manual

START OPERATION
When you apply the power to the LS-30 for the first time, the LCD display shows “System Reset”
& time information. This informs the user about the time of system power on. User can key in
“0000DC” to clear the display and entering the Initial State.
After entering the password, the user can select System Check function, Hot Key Control function or enter
Master, Installer and CMS modes.
Initial State
Master or User Password Installer or CMS Password
(*Only valid in Disarm Mode)
Hot Key Process System Check? Or Press Hot Key System Check?
Hot Key Enter Yes No Yes No
System Check Master Mode Installer Mode CMS Mode
(2) (3) (4) (5)
Hot Key: By pressing the keys below, you can enter into the specific operation mode directly.
For AWAY, HOME & DISARM Modes - refer to the OPERATION MODES OF LS-30.
The ARM Mode in this manual means AWAY or HOME Mode.
9
Enter AWAY Mode. (Quick Away: Press the key for 2 seconds to enter AWAY Mode from “Disarm”.
Ignore the password request.)
Enter HOME Mode. (Quick Home: Press the key for 2 seconds to enter Home Mode from “Disarm”.
Ignore the password request.)
Clear LED/LCD alarm/warning status, reset siren and stop dialing immediately.
Enter DISARM Mode & reset siren.
Enter hands
-
free Telephone Mode. The Base Unit can be used as a hands
-
free
telephone for 10 minutes when you enter this mode.
Press ESC to disconnect and return to normal operation.
Switch control (XRM-01 Relay Module and X-10 switch control module are optional.)
Close or open the alarm relay terminals on the rear panel.
Open Door (reserved).
Reading Come-In-Message (Refer to Appendix A-1)