Manualshelf

User's Manual

ManualsBrandsScientech Electronics ManualsElectronicsAlarm Base Unit
12345678910
The HMI (Human Machine Interface) of the LS-30 adopts the interactive programming technique, so
that all settings and operations can be done very easily just by answering YES or NO and
following the instructions on the display to enter figures.
Using the HMI
If the LCD shows a question mark (?), just answer by pressing the YES or NO button.
Ex: The LCD shows Master Mode? , Press the YES button to enter into Master Mode.
If the LCD shows the word Enter then key in proper figures followed by the Enter (D) key.
Ex: The LCD shows Seconds(0-255)
Enter:
The system asks the user to enter the figures between 0 and 255 and then press the Enter (D) key.
(If the user keys in 6 , 4, D, it means the timer is set at 64 seconds).
For all the Check functions, use the ↑ and ↓ keys to scroll up and down the screen.
Reading the programming flow chart
State A State A-1
Down arrow
Select the next state
State Loop A State A-2 Sub-state of State A-2
Right arrow
State A-3
Enter into the sub-state
Note: Pressing FUNC/ESC at any time will let you leave the current state loop.
Password
As many as 14 passwords can be set in the system, each with a max. of 8 digits.
Master Password (User1, default”0000”): The user with this password is authorized to manage
the other user passwords and user settings.
7 General User Passwords (User 2- 8): Open to 7 general users; with any of these passwords a
user can change operation modes, and check all the system status.
2 Latchkey User Passwords (User 9-10): User 9 and User 10 are also called Latchkey Users.
The LS-30 will dial the Latchkey Number (Refer to (4-2-1) Set Telephone Number-
Latchkey Number) when these users arm or disarm the system.
*Duress Code (User 11,default “8862”): Using this code to operate the system, the LS-30 will
send a duress signal to the CMS.
Installer Password (default”1234”): The user with this password is authorized to enter into the
Installer Mode.
2 CMS Passwords (CMS1 default “1111”, CMS2 default “2222”): Open to 2 CMS stations for
CMS parameter setting and system check.
8