User's Manual
ELECTRICAL INSTALLATION
1. Switch on the internal rechargeable battery.
The LS-30 Base Unit can accommodate 2 rechargeable battery packs.
Battery pack 1 is 9.6V/900mA(built-in) and Battery pack 2 (optional) is 9.6V/600mA, providing 6-15
hours back up time.
2. Plug in the power adaptor.
3. Key in Installer the password. (The default Installer password is “1234”.)
(Refer to the Passwords Block.)
4. Enter the Installer Mode. (Refer to (4) Installer Mode).
5. Program the basic settings
a) Telephone numbers
(Refer to (4-2) Set Telephone – (4-2-1) Set Telephone Number)
b) Record voice message
(Refer to (4-3) Set Sound-Record Voice)
c) Enroll all the wireless devices by recording their ID codes in the Base Unit.
(Refer to (4-4) Set Device-Enroll Device)
6. Set other functions if necessary.
7. Connect the telephone line, GSM module (if using GSM module for communication, refer to the
APPENDIX A-6) or Ethernet adaptor (if internet access is needed, refer to the APPENDIX A-3).
Note: For GSM module and Ethernet adaptor, please refer to their user guides.
8. Install the Wireless Siren and record the Base Unit’s ID code into the Wireless Siren.*
* This is only needed for a user with optional Wireless Siren.
(Refer to (4-5) Set Siren-Siren/Relay Test and the instructions with the Remote Siren)
9. Enter into Master Mode and adjust the clock. (Refer to (3) Master Mode – Set Clock)
10. Test other functions, if any have been set.
For details, please read the description on the following pages carefully.
All the above settings also can be done through the proprietary GUI program “HyperSecureLink”.
Please refer to the “HyperSecureLink” user guide.
Turn over the Base Unit, open the battery compartment
and push the battery switch to the ON (UP) position.
Note: If external power fails, the internal backup batteries can
supply operational power for 6 to 15 hours, depending on the
external load and the battery type in the Base Unit.
Batter
y
Switch Batter
y
1Batter
y
2
(
o
p
tional
)
5