User's Manual

APPENDIX
A-1. Remote Message Display.
A user or a CMS can send messages to the LS-30 if the Base Unit has been connected to the Internet
through the Ethernet Adaptor (optional) by using the HyperSecureLink program.
The LCD display will show “Messages Come In” and issue a warning sound periodically to remind the
user if any new message has been received by the LS-30 Base Unit. The user can check the message by
pressing (Hot Key) 5 after the password has been entered in Disarm Mode.
Up to ten 32-character messages with time tag can be stored in the memory of the Base Unit. Stop the
warning sound by pressing (Hot Key) C after entering the password.
(Note: ! and & are not allowed in the message)
A-2. Connection Diagram for RS-232 Computer Interface
COM1 cable RS-232 Adaptor HyperSecureLink Software
Note: If a serial COM port is not available on your PC, you can use a USB to COM Port Adaptor to connect to
your computer.
A-3. Connection Diagram for the Ethernet Adaptor and for Internet Remote Access
COM1 Cable Ethernet Adaptor Router
A-4. Connection Diagram for the X-10 Power Line Interface
X-10 Appliance Module X-10 power Line Interface Controller X-10 Cable
Internet
To LS-30
COM1
Power Line
To LS-30
COM2
HyperSecureLink or
CMS polling software
To PC
COM Port
To LS-30
COM1
36