User's Manual
Telephone Line Cut Detection: Permanent OFF /Away Mode ON /Permanent ON (default,
Permanent OFF)
The LS-30 can check the telephone line voltage and if the line is cut, the siren will go off (the
Inner Siren should be switched on) to alert the user. (refer to (4-5) Set Siren - Inner Siren.)
Permanent OFF: Never check the telephone line state.
Away Mode ON: Check the telephone line state only in AWAY mode.
Permanent ON: Always check the telephone line state.
Cease Dialing Mode: 30 Minutes /CMS Report OK (default, 30 Minutes)
30 Minutes: The auto-dialer stops dialing after 30 minutes or after all the telephone
numbers have been dialed 10 times without a successful connection.
CMS Report OK: The auto-dialer stops dialing after the report to CMS is successful.
Tel. Ring: ON/OFF (default, OFF)
Tel. Ring ON: Sound the ringer for incoming calls.
Tel. Ring OFF: Ringer deactivated for incoming calls.
Dial Tone Check: Enable/Disable (default, Enable)
Dial Tone Check Enable: The auto-dialer checks for a dial tone before dialing.
Dial Tone Check Disable: The auto-dialer will not check for a dial tone and dials immediately.
Tel/GSM/Ethernet Link: (default, Tel.)
Tel. Link: Dial out the alarm report from the telephone line.
GSM Link: Dial out the alarm report from the GSM module.
If a GSM link is used, refer to (4-7) Set GSM to set all the parameters needed
for GSM communication and APPENDIX A-6 for GSM link set up.
. Ethernet: If CMS report through the Ethernet link is required.
23