User's Manual

(4-2) Set Telephone Set Telephone Number (4-2-1)
Set Dial Mode Tone
Pulse 33/66
Pulse 40/60
Set Auto Answer Auto Answer On Set Ring Count
Auto Answer Off
Set Telephone Line Cut Detection Permanent Off
Away Mode On
Permanent On
Set Cease Dialing Mode 30 Minutes Due
CMS Report OK
Set Tel. Ringer Tel. Ringer On
Tel. Ringer Off
Set Dial Tone Check Dial Tone Check Enable
Dial Tone Check Disable
Set Tel/GSM Link
Dial Mode: Tone /Pulse 33/66 /Pulse 40/60 (default, Tone)
Check your telephone system and select the proper Pulse or Tone mode for the auto-dialer.
Auto Answer Ring Count: Auto Answer ON Ring Count 1-30 /Auto Answer OFF (default, Auto
Answer OFF)
Auto-Answer ON: The Base Unit will answer the incoming call automatically after the ring
count number set in this command has been reached. (You have to switch on this function,
if you want to use dial-in control. Three or more ring counts are recommended to avoid
triggering by noise.)
Auto Answer OFF: The Base Unit will not answer the incoming call.
22