User's Manual
DIAL-IN CONTROL
You can control and check with your LS-30 from a phone anywhere in the world by enabling the
auto-answer function (refer to (4-2) Set Telephone – Set Auto Answer) and set the ring count number.
Notes: 1. If you connect a fax machine or auto-answering machine on the same telephone line, you
might need to refer to their manuals and Appendix A-7 to avoid any disoperation.
2. The ring count number should be over three; otherwise, the noise on the telephone line may
trigger the dial-in control sequence.
3. Any phone set with pulse dialing will not connect with or control the system.
The operation of dial-in control is as follows:
1. Dial the telephone number to which LS-30 is connected.
2. After the preset ring count number, you will hear beeps.
3. Key in the password (preceded by * and followed by # ) from the telephone keypad within 30
seconds. If the password is correct, you will hear beeps again, otherwise you should enter the
password again.
4. After entering the valid password, the LS-30 will enter into monitoring mode for 30 seconds and then
-after two beeps- the system will enter into 2-way hands-free speaker phone automatically. Ten (10)
seconds before the termination of the telephone connection, one beep will be delivered to remind the
user.
5. During the 60 seconds, you can also enter commands from the telephone keypad to control the LS-30.
* 0 : Disarm the LS-30 (echoed by beeps) after you exit Dial-in Control.
* 1 : Arm the LS-30 in Home Mode (echoed by beeps) after you exit Dial-in Control.
* 2 : Arm the LS-30 in Away Mode (echoed by beeps) after you exit Dial-in Control.
* 4 : Check alarm event, hear voice message, or beeps if no alarm event.
* 5 : Enter 2-way hands-free speaker phone.
* 6 x x 1 : Turn on the switch number x x (01-16).
* 6 x x 0 : Turn off the switch number x x (01-16).
* 7 1 : Turn on the Relay.
* 7 0 : Turn off the Relay.
* 8 : Enter listen-only monitoring.
* 9 : Disconnect the line immediately.
Any other keys will extend the monitoring period for another 60 seconds (echoed by beeps).
The Process of Dial-in Control
Dial Phone Number Enter Password 60 sec. Monitoring &
within 30 seconds 2-way Communication
Ring count as user set *xx--xx# Ready for key tone command
18