User's Manual
OPERATION MODES OF LS-30
The LS-30 can be set into three operation modes to fulfill your requirements in different times and
situations.
AWAY M od e: When you leave your home or business, set the system into Away Mode. The LS-30
will scan all the sensors that have been set “on duty” and issue an alarm if any sensor detects
an abnormal condition after the Exit Delay passes.
(Hot Key) Enter into AWAY Mode
Away Mode Arming Sequence
Disarm Exit Delay AWAY mode active →
System status:
↑ beep! (0-255 seconds)
Set AWAY mode
Note: When you place the LS-30 in AWAY Mode, the Base Unit will check the status
of the Door Magnet sensors. If any of the sensors are still open (for example,
you forgot to close the back door before you leave), the Base Unit will issue a
warning message and show the zone number of the sensor on the LCD display
for you to check.
HOME Mode: In this operation mode, those burglar sensors with their Enable State - Home
Mode = Active will still be on alert and offer the protection you need while at home. (Refer
to (4 4-1) Installer Mode - Set Device - Change Device Setting - Burglar Sensor - Enable
State - Home Mode = Active.)
(Hot Key)
Enter HOME Mode
DISARM Mode: The LS-30 will not issue any alarm for Burglar sensors, but 24-Hour Zone
sensors (refer to (4-4-1) Change Device Setting - Burglar Sensor - 24-Hour Zone),
Fire sensors, Panic and Medical Buttons still work all the time.
(Hot Key)
Enter DISARM MODE
15