User's Manual

(3) Master Mode Set Bell Door Bell On
Device Test Door Bell Off
Monitor Mode
Set Partial ARM
Set Entry Delay (Refer to (4-1) Set Timer- Set Entry Delay.)
Set Exit Delay (Refer to (4-1) Set Timer- Set Exit Delay.)
Set Clock Time Date Day
Set Switch Set House Code
Set X-10 SW Auto Control
Set Relay Auto Control
Set Password Master
User 2
User 3 ~ User 7
User 8
User 9, (Latchkey User)
User10, (Latchkey User)
User 11(Duress Code)
Bell ON/OFF (default ON): Enable/Disable the doorbell chime.
Bell ON: In Disarm Mode, the Base Unit will issue a doorbell sound (Ding! Dong!) when receiving
a triggering signal from a Burglar sensor with its Bell ON/OFF status set in the ON state.
Bell OFF: No doorbell chime will sound.
Note: The Bell function only works for the Burglar Sensor if its Bell ON/OFF status is set
in the ON state. (refer to (4-4-1) Change Device Setting-Burglar Sensor-Enable State-Bell
ON/OFF)
13