User's Manual

INITIAL STATE
In the initial state, the LCD display shows DISARM & time information.
DISARM
10:04:05 FRI
After entering the password, the user can select System Check function, Hot Key Control function or enter
Master, Installer and CMS modes.
Initial State
Master or User Password Other Password
Hot Key Enter
Hot Key Process System Check? or Hot Key System Check?
Yes No Yes No
System Check Master Mode Installer Mode CMS Mode
(2) (3) (4) (5)
Hot Key: By pressing the keys below, you can enter into the specific operation mode directly.
For AWAY, HOME & DISARM Modes - refer to the OPERATION MODES OF LS-30.
The ARM Mode in this manual means AWAY or HOME Mode.
9
Enter AWAY Mode.
Enter HOME Mode.
Clear LED status, reset siren and stop dialing immediately.
Enter DISARM Mode & reset siren.
Enter hands-free Telephone Mode. The base unit can be used as a
hands-free telephone for 10 minutes when you enter this mode. Press
ESC
to disconnect and return to normal operation.
X-10 switch control (X-10 switch control module is an optional device).
Close or open the alarm relay terminals on the rear panel.
Open Door (reserved).