User's Manual

D.9, Change the IP address and the Gateway address of the PC to the same segment of the LS-10.
Ex: Since the IP address of LS-10 is 192.168.2.53 then set the IP address and Default gateway to
192.168.2. xx as below.
D.10, Run the VCOM again then LS-10 will be show on the “Searching” screen.
D.11, Open an Internet Browser and set the LS-10 according to your network requirement.
D12, Disconnect the Ethernet cable and put the cover back.
D13, Connect your PC and the LS-10 to the Internet.
D14, Restore your PC TCP/IP settings.