User's Manual

8. CONTROL AND PARAMETER SETTINGS
8.1 Control
*Siren Test: This test will activate the beeper, external alarm siren and send an Activate signal to
the Remote Siren (if a remote siren is installed) immediately.
*Device Test:
Enter into Device Test Mode for 5 minutes. Any trigger signal (not including the control
signal from Remote Controller) in this time will be treated as a test signal. After 5 minutes,
the system will exit from this mode automatically.
*External Alarm Siren Control: Turn On or Off the Alarm Siren connected on rear panel.
* Control Command Password: (default: Disable)
Disable: No password needed for the control commands.
Enable: Password must be attached to the control commands.
(If “Enable” then the password must be set and submitted when running the
HyperSecureLink software as below.)