User's Manual

Notes: Before you use KP-2S to control the system remotely, you have to
program a proper Exit/Entry Delay Time on the Base Unit.
Change Password
Note: 1. When you change your password, you have to delete the old RF
transmission code on LS-30 first, then re- register it.
2. The Installer should teach users how to change the password, so
they can change it when necessary.
Tampering Protection
If the correct password is not entered within 20 keystrokes, the KP-2S will lock up
for 5 minutes. All LEDs will remain off during this period, and all keystrokes are
ignored to prevent unauthorized tampering.
In addition, a radio signal of “tamper” will be sent if the battery hatch is opened.
This will trigger the siren if the system is disarmed, or the siren and auto-dialer, if
the system is armed.
Remarks: 1.The tamper signal can be re-triggered after 40 seconds, if the battery
hatch is opened again.
2.The tamper function can be enabled or disabled under \Installer
Mode\Set Siren menu on LS-30 Base Unit.
Low Battery Detection
When weak battery is detected, the backlit LED will flash with every keystrokes. If
the correct password is entered, the green LED will light. The KP-2S will work
about 20 times after low battery is detected.
*
Green LED lights
Press
3 seconds
then
release
new
p
assword
new password
once again
Green LED off when ke
y
p
ressed Green LED flashes
for 3 seconds