Setup guide

11.For software revisions higher than 4.15 (R415) when chamber pressure is higher

than 115kPa the PO field will switch to indicate the POS – Pressure Offset

Sterilization. During the sterilization phase, after adjusting the temperature, press

R&P key to select the PO field (PO field will be flashing) and using the keypad, adjust

the pressure offset POS to match the external meter pressure indication within 1 kPa.

NOTE: POS should not be more than 14 counts (7kPa) away in any direction from

POA.

TIP: To make sure the calibration has been done correctly, look at the external

meter. When it shows 136.5°C you should hear the valve clicking (the valve opens at

136.5°C).

12. Verify that for the rest of the calibration cycle the temperature and pressure 

readings (internal and external) are the same.

13. When the adjustment is complete, press the STOP button to end the chamber 

calibration cycle. Calibration cycle will end automatically after 5 min of holding the 

temperature above 134°C. Press the Stop button again to reset the unit.

NOTE: for software revisions higher than 4.15 (R415): If during recalibration POA 

is changed, the value of POS will be automatically reset to the new value of POA, 

therefore when chamber pressure is higher than 115kPa, POS has to be readjusted.

14. Power off the Statim.

Backup NVRAM:



15. It is recommended to Backup calibration data on completion of the Calibration

process. This data will automatically be reloaded to NVRAM in case the calibration

data is lost due to a power surge or other reason.

16. Power up unit in Service Mode (same as at 4 above) and scroll through the options

available using Unwrapped/ Wrapped key until Backup NVRAM option is on the first

line of the display. Select this option by pressing R&P key. Using Unwrapped key

change the NVRAM mode to ON and press R&P key to backup the NVRAM. The

display will show the backup progress in 0%, 50% and 100% percent. On completion

of this operation press STOP key to exit the Service Mode.

Calibration of the Statim S-Class autoclave is now complete.