Setup guide

57
13. Printer Interface Board rev 4.x Installation Instruction
When replacing a non-Rev 7x PCB of a Statim 5000(S) with printer with a rev 7.x PCB, the
printer PCB must be upgraded to rev 4.x.
Printer PCB Set-Up Instructions
Identify Statim PCB
revision
Statim PCB
Rev 2.4 - 6.4 ?
Replace printer PCB with
printer PCB rev. 4.x
configured as parallel
printer (see Note)
YES
Statim PCB
Rev 7.x or
higher?
Replace printer PCB with
printer PCB rev. 4.x
configured as serial
printer (see Note)
YES
No
Figure 1: Printer Interface board rev 4.x
Note:
- Jumpers ON at JP1-JP3 – serial printer configuration
- Jumpers OFF at JP1-JP3 – parallel printer configuration
Attach printer head
cable here. (Cable
from printer)
Attach serial printer
cable from Statim
Controller rev. 7.x or
higher
If using Rev 6.4 PCB,
remove all jumpers
and refer to note
below re:parallel
printer configuration.
Attach parallel printer
cable from Statim
Controller rev. 2.4 to 6.4