Setup guide

ManualsBrandsSciCan ManualsAutomotiveStatim 2000

11. Statim 2000S and 5000S Troubleshooting

Cycle Faults – Software Revision R4xx, R5xx and R6xx

Cycle Fault #70

The time maintained by the internal timer of the

processor didn’t match the time maintained by the

external real-time clock.

Transient electromagnetic disturbance (problem won’t

repeat). Damaged microprocessor or crystal (STATIM

Controller Board). Damaged real-time clock or crystal

(for software R4xx or R5xx pressure sensor interface

board).

Cycle Fault #71

Pressure reading is outside the possible range

Misconnected, disconnected or damaged pressure

sensor.

For software R4xx or R5xx disconnected or damaged

Pressure Sensor Interface Board.

Cycle Fault #72

Not used

Cycle Fault #90

Software Revisions R6xx

only

Corrupted or not initialized chamber calibration value

This occurs when a new controller board or

microprocessor has been installed. This may also

happen when the unit has been subjected to a strong

static discharge corrupting the memory. Calibrate

chamber thermocouple.

Cycle Fault #91

Software Revisions R6xx

only

Corrupted or not initialized pressure calibration

This occurs when a new controller board or

microprocessor has been installed. This may also

happen when the unit has been subjected to a strong

static discharge corrupting the memory. Calibrate

pressure sensor.

Cycle Fault #98

Microcontroller fails to communicate with ADC

(Analog to Digital Converter)

Hardware failure. MCU not inserted properly in the

socket, extract MCU, and verify pins not to be

shorted. Damaged ADC converter, replace PCB. If a

PCB adapter is used, verify that PCB adapter is

properly secured in the socket and that there are no

bent pins

“NO CONFIGURATION

EEPROM”

Lack of communication between microcontroller and

EEPROM

Hardware failure. MCU not inserted properly in the

socket, extract MCU, and verify pins not to be

shorted. Damaged or wrong inserted or missing

EEPROM, replace software kit. Damaged controller

PCB. If a PCB Adapter is used, verify that PCB

adapter is properly secured in the socket and that

there are no bent pins