Setup guide

26
Keypad
Unwrapped Increment current field
Wrapped Decrement current field
Rubber and Plastics Move to next field
Stop Exit Conductivity setup and save displayed thresholds,
“HH.H” and “LL.L”. Enter normal mode of operation.
2.5. Water.Cnd Tmp. Comp
Enable or disable water conductivity temperature compensation
>Water.Cnd Tmp. Comp
On
Off
Keypad
Unwrapped Select next option. Second line shows the new value
Wrapped Select previous option. Second line shows the new value
Rubber and Plastics Select and return to main menu
Stop Exit, without saving, to normal mode of operation
2.6. Stored CF Printouts
Print saved Cycle Fault printouts
The unit restarts to normal mode of operation. The saved CF printouts are sent to the
printer or data logger only when either one is attached and configured. The following
types of errors are saved:
• CF’s
• Water quality or Water level low errors
• Cycle interrupted due to errors (##)
Keypad
Stop Exit to normal mode of operation
2.7. Clear CF Printouts
Reset Cycle Fault printout list
>Clear CF Printouts
No
YES
Keypad
Unwrapped Select next option. Second line shows the new value
Wrapped Select previous option. Second line shows the new value
Rubber and Plastics Select and return to main menu
Stop Exit, without saving, to normal mode of operation