Setup guide

2. Service Menu

Note: To enter Service Menu power up Statim while holding Unwrapped and Wrapped

keys pressed. After that enter password to access Service menu. Default password is

Unwrapped, Wrapped, R&P and Stop keys in this order. The service technician can

change this password. In case the changed password is lost a backdoor password can

be used: Unwrapped, Wrapped, Unwrapped, Wrapped in this order.

To setup the advanced options of Statim select on of the following:

>Calibration

Time/Date Setup

Language Setup

Unit ID Setup

Set cycle counter

Lock cycles For S class units only

Conductivity Setup

Water.Cnd Tmp. Comp

Last Printout

Stored CF Printouts

Clear CF Printouts

Display last CF#

Devices Test On/Off

Temperature Offset

Press. Atm. Offset For S class units only

Press. Ster. Offset For S class units only

Press. Sensor Type For S class units only

Validation Offset For non-S class units only

Voltage Calibration

Voltage setup

Repeater mode

RS232

End of Line CR/LF

Serial Port Bitrate

Printer user ß char

Factory default

Change Password

Backup NVRAM

Restore NVRAM

Save and Exit

Exit

Water Pump Type

Production Cycle

Keypad

Unwrapped Select next item in the menu

Wrapped Select previous item in the menu

Rubber and Plastic Enter the indicated sub menu selection

Stop Exit and return to normal mode of operation