Setup guide

ManualsBrandsSciCan ManualsAutomotiveStatim 2000

8. Statim Rev. 7 PCB User and Service Menus

1. User setup menu.......................................................................................................................... 16

1.1 Time/Date Setup Mode ....................................................................................................... 16

1.2 Language Setup................................................................................................................... 17

1.3 Unit ID Setup......................................................................................................................... 17

1.4 Water Quality ........................................................................................................................18

1.5 Last Printout..........................................................................................................................18

1.6 RS232 .................................................................................................................................... 18

1.7 End of Line CR/LF ............................................................................................................... 19

1.8 Serial Port Bit Rate .............................................................................................................. 20

1.9 Printer user ° char ................................................................................................................ 20

1.10 Save and Exit........................................................................................................................ 20

1.11 Exit.......................................................................................................................................... 20

2. Service Menu................................................................................................................................ 21

2.1. Calibration ............................................................................................................................. 22

2.2. Set cycle counter.................................................................................................................. 24

2.3. Lock cycles............................................................................................................................ 24

2.4. Conductivity Setup............................................................................................................... 25

2.5. Water.Cnd Tmp. Comp ....................................................................................................... 26

2.6. Stored CF Printouts ............................................................................................................. 26

2.7. Clear CF Printouts ............................................................................................................... 26

2.8. Display last CF# ................................................................................................................... 27

2.9. Devices Test On/Off ............................................................................................................ 27

2.10. Temperature Offset.......................................................................................................... 27

2.11. Press. Atm. Offset............................................................................................................ 28

2.12. Press. Ster. Offset............................................................................................................ 28

2.13. Press. Sensor Type ......................................................................................................... 28

2.14. Validation Offset............................................................................................................... 29

2.15. Voltage Calibration........................................................................................................... 29

2.16. Voltage setup.................................................................................................................... 29

2.17. Repeater mode................................................................................................................. 30

2.18. Factory default.................................................................................................................. 30

2.19. Change Password............................................................................................................ 30

2.20. Backup NVRAM ...............................................................................................................31

2.21. Restore NVRAM............................................................................................................... 31

2.22. Water Pump Type ............................................................................................................ 31