Specifications

4
The unit can be operated using either the wireless remote or the front control panel.
1. On the rear of the purifier, switch the master power to the on position (the front display
will light up).
2. Press the
ON/OFF button on the front of purifier to power on the unit. The fan will start.
3. Press the Fan▲ and Fan▼ buttons to adjust the airflow speed to your desired level.
4. Press the Purify▲ and Purify▼ buttons to set the purifier setting from Stage 1 thru
Stage 5 to accommodate your desired level. You can operate the Purify feature and
the Sterilize feature simultaneously, but you cannot operate the Purify feature
and the Anion feature simultaneously.
5. Press the Sterilize button to operate the UVC and Photo Catalyst sanitize feature.
Press the Sterilize button again to stop its operation. The UVC bulb will produce a
light blue glow on the inside of the unit when this feature is on. Note: Do not look
directly at the UV Bulb while it is operating.
6. Press the Anion button to turn on the negative ion generator. A neon bulb in the unit
(behind the fan) will glow to indicate the negative ion generator is functioning properly.
The purify feature will stop automatically when the Anion feature is started. Press the
Anion button again to stop the negative ion generator function. You can operate the
Anion feature and the Sterilize feature simultaneously, but you cannot operate
the Anion feature and the Purify feature simultaneously.
Sleep Button
Press the Sleep button to use the screen saving mode. This will turn most of the
display lights off. Press any button on the front panel to deactivate the sleep mode.
The working mode of Anion, Purify, Sterilize, and fan speed will not change while in
sleep mode. If the timer function is set to turn the power off at a set time, do not use
the sleep function. The timer will only deactivate the sleep mode instead of shutting
down the unit if the sleep mode is on.
Time/Set Button
Read these instructions thoroughly before setting the time.
*** After 5 seconds of inactivity the clock will be set or you will have to start the process again. ***
The clock is a 24 hour clock; 13:00 would be 1:00p.m.
To set the current time:
1. Press the Time/Set button 2 times. “Time” on the display will blink.
2. The Purify▲ and Purify▼ buttons adjust the hours. The Fan▲ and Fan▼ buttons
adjust the minutes.
To set the power off timer:
1. While the unit is operating, press the Time/Set button 1 time. “Time/Set” on the
display will blink.
2. The Purify▲ and Purify▼ buttons adjust the hours. The Fan▲ and Fan▼ buttons
adjust the minutes.
GENERAL OPERATION
Power Switch Time Fan Speed Operating Display Operating Buttons
Sterilizer Feature Purifier Feature (5 Stages) Anion Feature
OFF
ON