Owner`s manual

9
Front plate – jumper configuration:
Jumper No. Function Position Default
Internal Sensor Control “B” Position X
JP1
External sensor control “A” Position
4 minutes delay for compressor Open X
JP3
No delay Short
Clock mode – 24 hours Open
JP4
Clock mode – 12 hours (AM/PM) Short X
JP5 NOT IN USE
“OUT,OUT” outputs not active Open
JP6
“OUT,OUT” outputs active Short X
Heat mode - Electric Open X
JP7
Heat mode - Oil/Gas Short
Base plate – jumper configuration:
Jumper No. Function Position Default
24Vac to “W1” output. “3” Position X
JP1
The “W1” and “MIL” outputs are
used to connect 2-wire Millivolt
system (dry contact)
“1” Position