Owner`s manual

2. Installation Instructions

It is very important to find the right place to install the Flush Mount unit.

Please make sure to follow all the installation instructions in order to get an

accurate reading of the temperature.

General points to follow:

• The unit MUST be fitted into a standard electrical box.

• The Unit must not be installed in the following cases:

 On an outside wall.

 When not having air draft inside.

 Exposed to direct sunlight.

• The standard height to install this unit is 5 feet (1.5 meter).

Installation procedure:

Disconnect quick connector from thermostat.

Connect the wires (see wiring connections #3)

Reconnect the quick connector back to the thermostat.

Put the thermostat in the electrical box.

Set the orientation as in the picture on the right.

Tighten up the 2 screws.

Adapt the front frame-panel into its place, by pushing it

towards the wall.