Specifications

4. SCHWINN Quick Shot: recommended for the threads of stabilizer bolts and pedals before tightening

to crank arms (part #72012)

HOW TO CHANGE A CHAIN IN THE 2006 SCHWINN INDOOR CYCLING PRO

/ELITE

/EVOLUTION/SR BIKES

Tools needed

1. 14-mm Wrench or Socket

2. 10mm Wrench

3. 4-mm Allen wrench

Procedure

Caution: Never touch the chain with a cloth our your hand while the chain is moving. Use the 4-

mm Allen wrench to remove the 3 screws of the outer chain guard and take off the guard. The outer guard

slides off easiest with the right pedal at 10 o'clock. Use the 14-mm wrench or socket to remove each axle

nut from the flywheel axle. Remove the chain tensioner bolts with a 10-mm wrench, which will allow you to

take off each chain adjustment bracket. Carefully lower the flywheel to the bottom of the frame. You can

now take the old chain off and put the new chain on. Carefully lift the flywheel back into place on the frame.

Reinstall each bracket to the axle and tighten each bolt evenly so the flywheel stays aligned with the frame.

Adjust the chain tension by locating the point where the chain is tightest during one revolution of the crank.

Check the tension; you should be able to move the chain up/down a total of 3/8” (in either direction), at the

tightest point. Once the chain is adjusted, reattach the outside chain guard using the three 4-mm Allen

head screws. Make sure the chain is properly lubricated prior to testing the bike. Listen for any grinding,

which could be caused by the chain tension being too tight or the flywheel being out of alignment with the

frame. Make any final adjustments.

HOW TO CHANGE A BOTTOM BRACKET IN THE 2006 SCHWINNINDOOR CYCLING PRO

/ELITE

/EVOLUTION/SR

BIKES

Tools needed

1. Bottom Bracket Tool (Part-#71717)

2. Pedal Wrench (#71695)

3. Crank Puller (#71699)

4. ISIS Insert Plug for Crank Puller, M12 x 1.0 17175

Torque Wrench

(#74523) w/8mm Allen key socket

mm Wrench

7. 10-mm Wrench

8. 4-mm Allen Wrench

9. 3/8” drive Socket Wrench

10. Adjustable Wrench

11. ISIS Insert Plug for Crank Puller, M12 x 1.0 (#71717)

11. 8-mm Allen Key wrench

Procedure