Specifications

3
Pop Pin Assembly (Double Lead) 84994 1
Plastic Sleeve 84966 1
Square Nuts 98022 5
Water Bottle Cages 84998 3
These are the tools and lubes that the NAUTILUS support team uses to properly assemble, maintain and repair
the SCHWINN Indoor Cycling bikes. Whether you will perform all of the functions “in house” or through a
service contract with an authorized NAUTILUS dealer, we strongly recommend that you keep each of these
items in stock.
The items in the maintenance kits will provide your facility with the tools and SCHWINNparts to keep your
bikes in top condition.
RECOMMENDED REPAIRS ON COMMON MOVING PARTS ON THE SCHWINN INDOOR CYCLING BIKES
Recommended Tools & Lubes
Tools needed
1. Torque wrench w/ 8-mm Allen Key socket: used to tighten the crank bolts of crank arms to 480 lbf/in.
(Torque wrench part #74523)
2. Pedal wrench: Has 15-mm and 9/16" wrench to tighten and loosen pedals (part #71695)
3. Crank puller: needed to take off right and left crank arms (part #71699)
4. ISIS Insert Plug for Crank Puller, M12 x 1.0 (part# 71715).
5. Bottom bracket tool for ISIS Overdrive BB: used to take out bottom bracket from frame (part #71717)
6. Adjustable wrench: used to tighten or loosen the pop pin assembly from frame.
7. 17-mm wrench: used to adjust the inside axle nuts closest to the flywheel bearings
8.
15
-
mm wrench: used to loosen the outside axle nut on each side of the flywheel when tightening
chain
9. 14-mm wrench: used to tighten the nuts of the seat bracket
40. 13-mm wrench: needed during assembly for the front and back stabilizers nuts and bolts
11. 11-mm wrench: used to tighten the larger bolt of the brake assembly
12. 10-mm wrench: used to adjust chain tensioner bolts during chain tightening, transport wheel nut and
bolt, and front nut of the resistance assembly when centering brake pads.
13. 8-mm wrench: goes to the smaller resistance knob nylon nut (older models) and smaller brake
assembly bolt
14.
7-mm wrench: used to loosen guide rod nut when replacing guide rod springs
14. 5-mm Allen wrench: Used to tighten the bolts on Evolution stabilizers.
16. 4-mm Allen wrench: used to loosen the bolt of the brake pads and the Allen chain guard screws
(newer models)
17. 3-mm Allen wrench: used for the screws of the water bottle cages
17.
Smart Release™ adjusting tool: High quality tool specifically designed for use with the new adjustable
Smart Release™ mechanism. (2002+ model bikes and newer). (Part$ 717
19).
Lubes needed
1.
SCHWINN Fit-Tech Silicone Spray: recommended for the brake pads and all moving parts I.E., handle
bar post, seat post & slide, pop-pins, resistance knob etc. (part #72016)
2. SCHWINN Equipment Polish: recommended on a damp cloth when wiping down the frame after use
(part #73200)
3.
SCHWINN Citrus Chain Wax: recommended to lubricate the chain through the rear hole in the chain
guard as the flywheel is rotating (part #72013)