Assembly Manual

Assembly
Step 1
Ref. # Description Qty
1 Frame 1
A Front Stabilizer Bar with Wheels and Feet 1
B Rear Stabilizer Bar with Feet 1
39 13mm Hex Bolt 4
50 Flat Washer 8
51 13mm Lock Nut 4
Tools Required
Stamped Steel Combination Wrench 1
Adjustable wrench or 13mm Socket 1
5mm Hex Tool 1
50
51
50
39
A
1
Front
1
39
50
50
51
B
Rear
A. Position the Front Stabilizer Bar (A) under the frame bracket
as shown in the illustration.
B. Make sure the adjustable feet are on the bottom and the
transport wheels are facing up and toward the front of the
bike.
CAUTION: IT IS VERY IMPORTANT TO APPLY GREASE TO
THE 13mm HEX BOLT (39) PRIOR TO MOUNTING THE 13mm
LOCKNUT (51). THIS WILL ENSURE THAT YOU CAN REMOVE
THE NUT AT A LATER DATE.
C. Attach Front Stabilizer Bar (A) to Frame (1) using two hex
bolts (39), four washers (50), and two lock nuts (51). Tighten
hardware firmly but do not over tighten as deformation of the
stabilizer tube may occur.
D. At this time make sure that the adjustable feet with lock nuts
are screwed fully into the stabilizer.
E. Position the Rear Stabilizer Bar (B) on the frame bracket as
shown in the illustration.
F. Make sure the adjustable feet are on the bottom.
G. Attach Rear Stabilizer Bar (B) to Frame (1) using two hex
bolts (39), four washers (50), and two lock nuts (51). Tighten
hardware firmly but do not over tighten as deformation of the
stabilizer tube may occur.
H. At this time make sure that the adjustable feet with lock nuts
are screwed fully into the stabilizer.
Assembly Manual
6