003-3790.060112.
Para obtener este manual en Español Latino Americano vaya a: http://www.schwinnfitness.com. Table of Contents Before Assembly 2 Hardware 4 Important Safety Instructions 2 Assembly 4 Specifications and Tools 3 Adjustments Parts 3 12 Nautilus, Inc., (800) NAUTILUS / (800) 628-8458, www.NautilusInc.com - Customer Service: North America (800) 605-3369, customerservice@schwinnfitness.com | Asia Pacific & Latin America (360) 859-5180, technics-APLA@nautilus.
Specifications and Tools Included Not Included #2 (recommended) 4mm 5mm 6mm (x2) (recommended) Parts R”) and left (“LL”) parts to assist with assembly.
Hardware Item Qty A 6 B Description Item Qty Flat Head Hex Screw, M8x25 J 2 Shaft 18 Button Head Hex Screw, M8x15 K 6 Flat Washer, M6 C 8 Flat Washer, M8 L 4 Button Head Hex Screw, M6x12 D 18 Spring Washer, M8 M 2 Wave Washer,Small (D16.5) E 4 Flat Washer, Wide N 2 Sleeve, Plastic F 2 Washer O 2 Wave Washer,Large (D20) G 6 Button Head Hex Screw, M6x15 P 4 Plastic Washer (D16.
2. Attach Rail Assembly to Frame Assembly 3. Connect the Console Cable Note: The cables must be fully connected for the Console to operate. Do not crimp the Console Cable.
4. Attach Console Mast to Frame Assembly Note: Do not crimp the Console Cable. 5. Attach Lower Handlebar Arms to Frame Assembly Note: Only tighten this Hardware until secure.
6. Attach Upper Handlebar Arms to Frame Assembly 7. Attach Pedal Arms to Frame Assembly Note: Only tighten this Hardware until secure.
. Attach Legs to Frame Assembly 9.
10. Attach Console to Frame Assembly Note: Be sure the switch on the back of the Console is set to E. The cables must be fully connected for the Console to operate. Do not crimp the Console Cable. * Hardware is pre-installed on Console and not on the Hardware Card. 11. Attach Water Bottle Holder to Frame Assembly * Hardware is pre-installed and not on the Hardware Card.
12. Tighten all Hardware Note: Fully tighten all Hardware from the previous steps except where noted to only secure. 13. Install Batteries in Console Note: The console uses D size batteries (LR20), which are not included. Make sure that the batteries point in the direction of the +/– indicators in the battery bay. If you use rechargeable batteries, the optional power adapter will not recharge the batteries. Do not mix old and new batteries.
Optional Power Adapter The console for your machine can operate on battery power or AC power. For AC power, it is necessary to order the optional Power Adapter. If batteries and the Power Adapter are installed, the console will use the Power Adapter to operate. Note: If you use rechargeable batteries, the optional Power Adapter will not recharge the batteries. After the machine is fully assembled, connect the Power Adaptor to the console and the wall outlet.
Adjustments Moving the Machine Do not move the machine without aid. Injury to you or damage to the machine can occur. 1. Remove the power cord (if equipped). 2. Use the back of the Rail Assembly to carefully lift the machine onto the transport rollers. 3. Push the machine into position. 4. Carefully lower the machine into position. Leveling the Machine The machine needs to be leveled if your workout area is uneven or if the Rail Assembly is slightly off the floor. To adjust: 1.
Printed in China
