User's Manual

Date Code 20091009 SEL-3031 Instruction Manual
Performance Monitoring, Testing, and Troubleshooting
Troubleshooting
5.7
The Remote radio will not
link up to the Master.
Radio address or mode is
not set correctly.
The Master and Remote
radios must be set to the
same address and have the
same SKIP settings. Check
that the Master radio LINK
light is ON and that the NID
address and SKIP setting is
set correctly on both units.
Antennas are not pointed
correctly, or there is a bad
antenna cable.
Use
ACSELERATOR Quick-
Set on the radio to issue the
RAD command to check for
signal strength. If the signal
is low, try to re-aim both
antennas to gain signal
strength and check for bad
antenna cables. See
Section 2: Installation for
more information on proper
radio installation.
Table 5.2 Troubleshooting Tips (Sheet 2 of 2)
Symptom Probable Cause Corrective Action