User's Manual

Date Code 20091009 SEL-3031 Instruction Manual
Settings and Commands
Commands
4.25
TIME Command
Use TIME to return information about the SEL-3031 internal clock, as shown in
Table 4.23. You can specify hours and minutes (seconds data are optional). Separate
the hours, minutes, and seconds with colons, semicolons, spaces, commas, or slashes.
t
Enter TIME hh:mm and TIME hh:mm:ss to set the internal clock time. The value hh
is for hours 0–23; the value mm is for minutes 0–59; the value ss is for seconds 0–59. If
you enter a valid time, the device will update, save the time in nonvolatile memory, and
display the time entered. If you enter an invalid time, the SEL-3031 will respond with
Invalid Time.
FLASH Nonvolatile memory integrity OK/FAIL
SDRAM Integrity of code that runs in RAM OK/FAIL
RADIO Radio module status OK/FAIL
RTC Real-Time Clock status OK/FAIL
SEC SEL-3044 Encryption Card status OK/ABSENT/RESET/FAIL
Table 4.23 Command Definitions
Command Description Access Level
TIME Displays the present internal clock time. 1
TIME hh:mm Sets the internal clock to hh:mm.1
TIME hh:mm:ss Sets the internal clock to hh:mm:ss.1
Table 4.22 STA Command Report (Sheet 2 of 2)
Status Report
Designator
Definition Message Format