User's Manual

Date Code 20091009 SEL-3031 Instruction Manual
Settings and Commands
Commands
4.23
If you want to set all of the Radio settings, issue the SET R command and it will start
at the beginning of the settings list. Enter the desired setting value or press <Enter> to
accept the existing setting, as shown in Ta bl e 4.19.
The device checks each setting to ensure that it is within the allowed range. If the
setting is not within the allowed range, the device generates an
Out of Range
message and prompts you for the setting again. When all the settings are entered, the
device displays the new settings and prompts you for approval to enable them. Answer
Y <Enter> to enable the new settings. The device is disabled for no longer than one
second while saving the new settings. The ALARM LED illuminates momentarily and the
ENABLED LED extinguishes while the device is disabled.
SHOW Command
When showing settings, the radio displays the settings label and the present value from
nonvolatile memory for each setting class as shown in Table 4 .2 0.
Append s and the specific settings name you want to view in the SHOW command to
immediately jump to the setting. If s (and the settings name) is not included, the device
presents settings beginning with the first in the group.
Table 4.19 SET Command Editing Keystrokes
Press Key Results
<Enter> Retains the setting and moves to the next setting.
^<Enter> Returns to the previous setting.
< <Enter> Returns to the previous setting category.
> <Enter> Moves to the next setting category.
END <Enter> Exits the editing session, then prompts you to save the settings.
<Ctrl+X> Aborts the editing session without saving changes.
Table 4.20 SHO Command (Show/View Settings)
Command Description Access Level
SHO G s Show Global settings 1
SHO R s Show Radio settings 1
SHO P s Show serial Port settings 1