User's Manual

Date Code 20091009 SEL-3031 Instruction Manual
Section 2
Installation
Overview
RF Exposure Notice
The SEL-3031 transmitter module is approved for use only with specific
antenna, cable, and output power configurations that have been tested and
approved for use. Modifications to the SEL-3031, the antenna system, or
to the power output that have not been explicitly specified by the
manufacturer are not permitted and may render the radio non-compliant with
applicable regulatory authorities. The radio equipment described in this manual emits
radio frequency energy. Professional installation is required. The antenna(s) for this
transmitter must not be colocated or operated in conjunction with any other antenna or
transmitter.
!
CAUTION
Although the power level is low, concentrated energy from a directional
antenna may pose a health hazard. Do not allow users to come closer than
23 cm (9 in) to the antenna when the transmitter is operating in indoor or
outdoor environments in the 900-MHz band.
FCC Part 15 Notice
NOTE: Operation is subject to the following two conditions:
(1) this device may not cause interference, and (2) this
device must accept any interference, including
interference that may cause undesired operation of the
device.
This equipment has been tested and found to comply with the limits for Class A digital
devices, pursuant to FCC Part 15 Rules. These limits are designed to provide
reasonable protection against harmful interference when the equipment is operated in a
commercial environment. This equipment generates, uses, and radiates radio frequency
energy, and if not installed and used in accordance with the instruction manual, may
cause harmful interference to radio communications. Operation of this equipment in a
residential environment is likely to cause harmful interference, in which case the user
will be required to correct the interference at his/her own expense.
RF EXPOSURE