Information Sheet

7
Date Code 20191014 Information Sheet SEL-734W and SEL-WCS
Safety Information
Safety Information
Regulatory Information
The SEL-WCS is approved for use only with specific output power configura-
tions that have been tested and approved. Modifications to the SEL-WCS, the
antenna system, and the power output that have not been explicitly specified by
the manufacturer are not permitted and may render the radio noncompliant with
applicable regulatory authorities. The radio equipment described in this manual
emits radio frequency energy. Professional installation is required.
United States (FCC)
Per FCC 15.19(a)(3) and (a)(4) This device complies with part 15 of the FCC
Rules. Operation is subject to the following two conditions: (1) This device may
not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
Per FCC 15.21, changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate the equip-
ment.
Canada
DANGER
Install fault transmitters and
sensors in accordance with
normal safe operating
procedures. These instructions
are not intended to replace or
supersede existing safety or
operating requirements. Only
trained qualified personnel with
knowledge of high voltage
safety should install or operate
fault transmitters.
CAUTION
Although the power level is low,
concentrated energy from a
directional antenna may pose a
health hazard. Do not allow
users to come closer than 23 cm
(9 in) to the transmitter when it
is operating.
DANGER
To ensure proper safety and
operation, the equipment
ratings, installation instructions,
and operating instructions must
be checked before
commissioning or maintenance
of the equipment. The integrity
of any protective conductor
connection must be checked
before carrying out any other
actions. It is the responsibility of
the user to ensure that the
equipment is installed,
operated, and used for its
intended function in the manner
specified in this manual. If
misused, any safety protection
provided by the equipment may
be impaired.
This device complies with Industry Canada
license-exempt RSS standard(s). Operation is
subject to the following two conditions: (1)
this device may not cause interference, and
(2) this device must accept any interference,
including interference that may cause unde-
sired operation of the device.
Le présent appareil est conforme aux CNR
d'Industrie Canada applicables aux appareils
radio exempts de licence. L'exploitation est
autorisée aux deux conditions suivantes : (1)
l'appareil ne doit pas produire de brouillage ;
(2) l'utilisateur de l'appareil doit accepter tout
brouillage radioélectrique subi, même si le
brouillage est susceptible d'en compromettre
le fonctionnement.
Per RSS-Gen, Radio apparatus shall comply
with the requirements to include required
notices or statements to the user of equipment
with each unit of equipment model offered for
sale.
Selon RSS-Gen, un appareil radio doit être
conforme avec les exigences d'inclure requis
avis ou déclarations à l'utilisateur de l'équipe-
ment avec chaque unité de modèle d'équipe-
ment offert pour vente.
These statements are required regarding
antennas and for certain types of equipment.
Please see the specified sections of RSS-Gen
for details and suggested verbiage: Transmit-
ter Antenna -Section 6.8
Ces déclarations sont obligatoires concernant
antennes et pour certains types d'équipement.
Veuillez consulter les sections spécifiées de
RSS-Gen pour plus de détails et le verbiage
suggéré: Emetteur Antenne - Section 6.8
Devices operating in the 5250 - 5350 MHz
band shall be labeled "for indoor use only".
Alternatively, that text can be included in the
user manual and not on the device. Note how-
ever the user manual is the only option avail-
able for devices operating in the 5150 - 5250
MHz band. In all cases the user manual shall
contain instructions "for indoor use only".
Périphériques fonctionnant dans la bande
5250 - 5350 MHz la bande doit porter la men-
tion "pour utilisation à l'intérieur unique-
ment". Alternativement, ce texte peut être
inclus dans le manuel de l'utilisateur et non
sur l'appareil. Notez cependant le manuel
d'utilisation est la seule option disponible
pour les appareils fonctionnant dans le 5150 –
5250 Bande MHz. Dans tous les cas, le man-
uel d'utilisation doit contient des instructions
"pour une utilisation en intérieur uniquement".