Installation and Operation Guide

Page 16
7. Installation
Flexible Ducting for Isodrive Motor System
For the Isodrive motor, please do not crush or kink exi ducting, as it will reduce air ow and may
cause noise to occur through the system. Ducting needs to be kept taut at all times. Please refer to
the Isodrive motor installation guide for more details on exi ducting with the silent system.
Single IsoDrive Motor Installation
*NOTE: Isodrive motor DOES NOT include roof seal kit and support straps. Weather shield only
available for Isodrive 1600 motor, please attach it the motor
1
.
Isodrive Motor
1
Roof Seal Kit (Dektite)*
Support Straps*
Motor Power Lead (Male Plug)
Rangehood to Motor Lead
(Female Plug)
Attach Flexi Duct to Bell-Mouth
Adaptor using aluminium foil
tape or cable tie etc. Please DO
NOT rip the ducting.
2
3
5
6
4
1
2
3
4
5
6
7
8
9
10
Main Power Lead (Male Plug)
Multi-t Y Joint, cut to 200 x
200 x 200mm
Flexi Ducting must be pulled
taut. DO NOT crush or kink
the ducting.
Connect exi ducting to the
outlet on rangehood using
aluminium foil tape or cable tie.
Please DO NOT rip the ducting.
8
7
9
10
This picture is for illustrative purposes only, not to scale.
200mm
Flexi Duct
200mm
Flexi Duct