Installation Guide

Page 17
Figure 11 Roof mount option
Twin 200mm Outlet Installation Example
This is for use where one motor is to be used and there are two 200mm outlets, refer gure 11.
Try to keep length of
exible ducting as
even as possible other
wise motors will draw
air off each other
Ensure exible ducting
is fully extended and as
short as possible. Use
smooth owing curves
for maximum air ow.
Remove excess ducting
by trimming to length.
200 x 200 x 200mm
If multi-t Y joint supplied
you will need to cut to size.
1600 motor
4. Installation