Installation Guide

Page 12

4. Installation

Figure 4

Flat Roof Installation

Flat roof mounting using optional mounting ange*.

PED

Engage locking

screws in holes

Seal 3 holes in

stepped surface

Seal between mounting

ange and cover

Up-stand and

capping

Power supply

cord passing

through pipe slots

NOTE: Cut 150mm PVC

stormwater pipe to length and

reslot ducting end. Ensure that

fan end locking holes remain

200mm Flexible

Ducting

Seal top edge of ange

Protrusion of pipe

above mounting ange

Bond ange to pipe using

silicone, urethane or type

‘N’ PVC solvent cement

Optional mounting

ange P40113MF*

Roof Cladding

1600

motor

IMPORANT

For more exible ducting instructions, refer page 22. Shutter assembly for 1600 motor is not

shown in the diagram. Weather shield (for 1600 motor only) should be installed to prevent

rain/water entering the unit.

*Optional wall mounting ange (P40113MF) is available

from Schweigen, please contact 1300 829 066.